If I get Bell to send out a tech will he say there is nothing he can do once he finds I'm running DPP equipment? No problem with SD programming.Īny ideas anyone, I've checked all the cables and both receivers are doing the same thing. I can usually watch my HD channels it's just very finicky and frustrating when I change to another HD channel, there's a 50/50 chance it will work. And when I get the 004 error and hit OK the channel will sometimes work right away other times a few minutes later and still other times just won't work. So then I'll go to an HD channel like Oasis and it works? It will work 50% of the time. Test switch is OK for 38 of 38 transponders on input 1 (trans.82)but input 2 can't find anything, at the end I get the error "warning the check switch has found you have fewer sats than previously detected". Not getting a signal on "point dish Sat.91" although if I browse through the transponders I'll occasionally get a good signal on a transponder. Eventually channels will connect and have never lost a signal while on any given HD channel. Will go to change a channel and get a 044 error on screen. In the last couple of weeks I've been having problems with HD channels(ever since Bell upgraded my channel lineup for less cost?). Had this setup for a number of years now. Equipment Quad DPP LNB, DPP44, DPP Separator to the 9141 & 9142 revicers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |